excited, not least from the commentary by Siglinde and their demand for a weather protection for the winter I have the post office ( click ) the day before yesterday I made again and completed. How
Siglinde, had expressed similar concerns, my wife already, with the words "yes do you want the poor little creature, the sunflower seeds offer frozen rain and wet in winter?" So again
was working the day.
I had a flower pot stand concerned with 24cm diameter (1.50 € in the previously mentioned store)
middle of this mat with a 50mm hole saw a hole drilled
or here increases in the following
Then I split the feed station again, that is, simply The three round wooden rods pull out and remove the bottom DN100 sleeve stopper.
Then, as in the following image first drilled through the base, then slide the rubber seal on the DN50 pipe from below. The rubber seal is the same that I had taken during the assembly of the upper sleeve of the pipe.
Moving the black sealing ring You can adjust the spacing of the roof. The seal is concentrated in a specific location (try it by rolling on the tube), if the outside is the inside of the sealing ring, he is better than one. Also clean the rubber ring and thus remove the existing lubricant brings better support. If these measures do not lead to a sufficiently dense layer of the roof, then if necessary a bead of adhesive with the gun under the roof will put around the tube.
Then the ground and the perching refit and is ready to weatherproof feeding station.
in my garden looks the part at the end of the modification to the following:
0 comments:
Post a Comment